[Docs] [txt|pdf] [draft-hoffman-s...] [Tracker] [Diff1] [Diff2]
Obsoleted by: 3207 PROPOSED STANDARD
Network Working Group P. Hoffman
Request for Comments: 2487 Internet Mail Consortium
Category: Standards Track January 1999
SMTP Service Extension for Secure SMTP over TLS
Status of this Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (1999). All Rights Reserved.
1. Abstract
This document describes an extension to the SMTP service that allows
an SMTP server and client to use transport-layer security to provide
private, authenticated communication over the Internet. This gives
SMTP agents the ability to protect some or all of their
communications from eavesdroppers and attackers.
2. Introduction
SMTP [RFC-821] servers and clients normally communicate in the clear
over the Internet. In many cases, this communication goes through one
or more router that is not controlled or trusted by either entity.
Such an untrusted router might allow a third party to monitor or
alter the communications between the server and client.
Further, there is often a desire for two SMTP agents to be able to
authenticate each others' identities. For example, a secure SMTP
server might only allow communications from other SMTP agents it
knows, or it might act differently for messages received from an
agent it knows than from one it doesn't know.
TLS [TLS], more commonly known as SSL, is a popular mechanism for
enhancing TCP communications with privacy and authentication. TLS is
in wide use with the HTTP protocol, and is also being used for adding
security to many other common protocols that run over TCP.
Hoffman Standards Track [Page 1]
RFC 2487 SMTP Service Extension January 1999
2.1 Terminology
The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC-2119].
3. STARTTLS Extension
The STARTTLS extension to SMTP is laid out as follows:
(1) the name of the SMTP service defined here is STARTTLS;
(2) the EHLO keyword value associated with the extension is STARTTLS;
(3) the STARTTLS keyword has no parameters;
(4) a new SMTP verb, "STARTTLS", is defined;
(5) no additional parameters are added to any SMTP command.
4. The STARTTLS Keyword
The STARTTLS keyword is used to tell the SMTP client that the SMTP
server allows use of TLS. It takes no parameters.
5. The STARTTLS Command
The format for the STARTTLS command is:
STARTTLS
with no parameters.
After the client gives the STARTTLS command, the server responds with
one of the following reply codes:
220 Ready to start TLS
501 Syntax error (no parameters allowed)
454 TLS not available due to temporary reason
A publicly-referenced SMTP server MUST NOT require use of the
STARTTLS extension in order to deliver mail locally. This rule
prevents the STARTTLS extension from damaging the interoperability of
the Internet's SMTP infrastructure. A publicly-referenced SMTP server
is an SMTP server which runs on port 25 of an Internet host listed in
the MX record (or A record if an MX record is not present) for the
domain name on the right hand side of an Internet mail address.
Hoffman Standards Track [Page 2]
RFC 2487 SMTP Service Extension January 1999
Any SMTP server may refuse to accept messages for relay based on
authentication supplied during the TLS negotiation. An SMTP server
that is not publicly referenced may refuse to accept any messages for
relay or local delivery based on authentication supplied during the
TLS negotiation.
A SMTP server that is not publicly referenced may choose to require
that the client perform a TLS negotiation before accepting any
commands. In this case, the server SHOULD return the reply code:
530 Must issue a STARTTLS command first
to every command other than NOOP, EHLO, STARTTLS, or QUIT. If the
client and server are using the ENHANCEDSTATUSCODES ESMTP extension
[RFC-2034], the status code to be returned SHOULD be 5.7.0.
After receiving a 220 response to a STARTTLS command, the client
SHOULD start the TLS negotiation before giving any other SMTP
commands.
If the SMTP client is using pipelining as defined in RFC 1854, the
STARTTLS command must be the last command in a group.
5.1 Processing After the STARTTLS Command
After the TLS handshake has been completed, both parties MUST
immediately decide whether or not to continue based on the
authentication and privacy achieved. The SMTP client and server may
decide to move ahead even if the TLS negotiation ended with no
authentication and/or no privacy because most SMTP services are
performed with no authentication and no privacy, but some SMTP
clients or servers may want to continue only if a particular level of
authentication and/or privacy was achieved.
If the SMTP client decides that the level of authentication or
privacy is not high enough for it to continue, it SHOULD issue an
SMTP QUIT command immediately after the TLS negotiation is complete.
If the SMTP server decides that the level of authentication or
privacy is not high enough for it to continue, it SHOULD reply to
every SMTP command from the client (other than a QUIT command) with
the 554 reply code (with a possible text string such as "Command
refused due to lack of security").
The decision of whether or not to believe the authenticity of the
other party in a TLS negotiation is a local matter. However, some
general rules for the decisions are:
Hoffman Standards Track [Page 3]
RFC 2487 SMTP Service Extension January 1999
- A SMTP client would probably only want to authenticate an SMTP
server whose server certificate has a domain name that is the
domain name that the client thought it was connecting to.
- A publicly-referenced SMTP server would probably want to accept
any certificate from an SMTP client, and would possibly want to
put distinguishing information about the certificate in the
Received header of messages that were relayed or submitted from
the client.
5.2 Result of the STARTTLS Command
Upon completion of the TLS handshake, the SMTP protocol is reset to
the initial state (the state in SMTP after a server issues a 220
service ready greeting). The server MUST discard any knowledge
obtained from the client, such as the argument to the EHLO command,
which was not obtained from the TLS negotiation itself. The client
MUST discard any knowledge obtained from the server, such as the list
of SMTP service extensions, which was not obtained from the TLS
negotiation itself. The client SHOULD send an EHLO command as the
first command after a successful TLS negotiation.
The list of SMTP service extensions returned in response to an EHLO
command received after the TLS handshake MAY be different than the
list returned before the TLS handshake. For example, an SMTP server
might not want to advertise support for a particular SASL mechanism
[SASL] unless a client has sent an appropriate client certificate
during a TLS handshake.
Both the client and the server MUST know if there is a TLS session
active. A client MUST NOT attempt to start a TLS session if a TLS
session is already active. A server MUST NOT return the TLS extension
in response to an EHLO command received after a TLS handshake has
completed.
6. Usage Example
The following dialog illustrates how a client and server can start a
TLS session:
S: <waits for connection on TCP port 25>
C: <opens connection>
S: 220 mail.imc.org SMTP service ready
C: EHLO mail.ietf.org
S: 250-mail.imc.org offers a warm hug of welcome
S: 250 STARTTLS
C: STARTTLS
S: 220 Go ahead
C: <starts TLS negotiation>
Hoffman Standards Track [Page 4]
RFC 2487 SMTP Service Extension January 1999
C & S: <negotiate a TLS session>
C & S: <check result of negotiation>
C: <continues by sending an SMTP command>
. . .
7. Security Considerations
It should be noted that SMTP is not an end-to-end mechanism. Thus, if
an SMTP client/server pair decide to add TLS privacy, they are not
securing the transport from the originating mail user agent to the
recipient. Further, because delivery of a single piece of mail may
go between more than two SMTP servers, adding TLS privacy to one pair
of servers does not mean that the entire SMTP chain has been made
private. Further, just because an SMTP server can authenticate an
SMTP client, it does not mean that the mail from the SMTP client was
authenticated by the SMTP client when the client received it.
Both the STMP client and server must check the result of the TLS
negotiation to see whether acceptable authentication or privacy was
achieved. Ignoring this step completely invalidates using TLS for
security. The decision about whether acceptable authentication or
privacy was achieved is made locally, is implementation-dependant,
and is beyond the scope of this document.
The SMTP client and server should note carefully the result of the
TLS negotiation. If the negotiation results in no privacy, or if it
results in privacy using algorithms or key lengths that are deemed
not strong enough, or if the authentication is not good enough for
either party, the client may choose to end the SMTP session with an
immediate QUIT command, or the server may choose to not accept any
more SMTP commands.
A server announcing in an EHLO response that it uses a particular TLS
protocol should not pose any security issues, since any use of TLS
will be at least as secure as no use of TLS.
A man-in-the-middle attack can be launched by deleting the "250
STARTTLS" response from the server. This would cause the client not
to try to start a TLS session. An SMTP client can protect against
this attack by recording the fact that a particular SMTP server
offers TLS during one session and generating an alarm if it does not
appear in the EHLO response for a later session. The lack of TLS
during a session SHOULD NOT result in the bouncing of email, although
it could result in delayed processing.
Hoffman Standards Track [Page 5]
RFC 2487 SMTP Service Extension January 1999
Before the TLS handshake has begun, any protocol interactions are
performed in the clear and may be modified by an active attacker. For
this reason, clients and servers MUST discard any knowledge obtained
prior to the start of the TLS handshake upon completion of the TLS
handshake.
The STARTTLS extension is not suitable for authenticating the author
of an email message unless every hop in the delivery chain, including
the submission to the first SMTP server, is authenticated. Another
proposal [SMTP-AUTH] can be used to authenticate delivery and MIME
security multiparts [MIME-SEC] can be used to authenticate the author
of an email message. In addition, the [SMTP-AUTH] proposal offers
simpler and more flexible options to authenticate an SMTP client and
the SASL EXTERNAL mechanism [SASL] MAY be used in conjunction with
the STARTTLS command to provide an authorization identity.
Hoffman Standards Track [Page 6]
RFC 2487 SMTP Service Extension January 1999
A. References
[RFC-821] Postel, J., "Simple Mail Transfer Protocol", RFC 821,
August 1982.
[RFC-1869] Klensin, J., Freed, N, Rose, M, Stefferud, E. and D.
Crocker, "SMTP Service Extensions", STD 10, RFC 1869,
November 1995.
[RFC-2034] Freed, N., "SMTP Service Extension for Returning Enhanced
Error Codes", RFC 2034, October 1996.
[RFC-2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[SASL] Myers, J., "Simple Authentication and Security Layer
(SASL)", RFC 2222, October 1997.
[SMTP-AUTH] "SMTP Service Extension for Authentication", Work in
Progress.
[TLS] Dierks, T. and C. Allen, "The TLS Protocol Version 1.0",
RFC 2246, January 1999.
B. Author's Address
Paul Hoffman
Internet Mail Consortium
127 Segre Place
Santa Cruz, CA 95060
Phone: (831) 426-9827
EMail: phoffman@imc.org
Hoffman Standards Track [Page 7]
RFC 2487 SMTP Service Extension January 1999
C. Full Copyright Statement
Copyright (C) The Internet Society (1999). All Rights Reserved.
This document and translations of it may be copied and furnished to
others, and derivative works that comment on or otherwise explain it
or assist in its implementation may be prepared, copied, published
and distributed, in whole or in part, without restriction of any
kind, provided that the above copyright notice and this paragraph are
included on all such copies and derivative works. However, this
document itself may not be modified in any way, such as by removing
the copyright notice or references to the Internet Society or other
Internet organizations, except as needed for the purpose of
developing Internet standards in which case the procedures for
copyrights defined in the Internet Standards process must be
followed, or as required to translate it into languages other than
English.
The limited permissions granted above are perpetual and will not be
revoked by the Internet Society or its successors or assigns.
This document and the information contained herein is provided on an
"AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Hoffman Standards Track [Page 8]
Html markup produced by rfcmarkup 1.129b, available from
https://tools.ietf.org/tools/rfcmarkup/
