[Docs] [txt|pdf] [draft-ietf-mip6...] [Tracker] [Diff1] [Diff2] [Errata]
PROPOSED STANDARD
Errata Exist
Network Working Group A. Patel
Request for Comments: 4283 K. Leung
Category: Standards Track Cisco Systems
M. Khalil
H. Akhtar
Nortel Networks
K. Chowdhury
Starent Networks
November 2005
Mobile Node Identifier Option for Mobile IPv6 (MIPv6)
Status of This Memo
This document specifies an Internet standards track protocol for the
Internet community, and requests discussion and suggestions for
improvements. Please refer to the current edition of the "Internet
Official Protocol Standards" (STD 1) for the standardization state
and status of this protocol. Distribution of this memo is unlimited.
Copyright Notice
Copyright (C) The Internet Society (2005).
Abstract
Mobile IPv6 (MIPv6) defines a new Mobility header that is used by
mobile nodes, correspondent nodes, and home agents in all messaging
related to the creation and management of bindings. Mobile IPv6
nodes need the capability to identify themselves using an identity
other than the default home IP address. Some examples of identifiers
include Network Access Identifier (NAI), Fully Qualified Domain Name
(FQDN), International Mobile Station Identifier (IMSI), and Mobile
Subscriber Number (MSISDN). This document defines a new mobility
option that can be used by Mobile IPv6 entities to identify
themselves in messages containing a mobility header.
Patel, et al. Standards Track [Page 1]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
Table of Contents
1. Introduction ....................................................2
2. Terminology .....................................................3
3. Mobile Node Identifier Option ...................................3
3.1. MN-NAI Mobility Option .....................................4
3.2. Processing Considerations ..................................4
4. Security Considerations .........................................4
4.1. General Considerations .....................................4
4.2. MN-NAI Considerations ......................................4
5. IANA Considerations .............................................5
6. Acknowledgements ................................................5
7. Normative References ............................................5
8. Informative Reference ...........................................6
1. Introduction
The base specification of Mobile IPv6 [RFC3775] identifies mobility
entities using an IPv6 address. It is essential to have a mechanism
wherein mobility entities can be identified using other identifiers
(for example, a Network Access Identifier (NAI) [RFC4282],
International Mobile Station Identifier (IMSI), or an application/
deployment specific opaque identifier).
The capability to identify a mobility entity via identifiers other
than the IPv6 address can be leveraged for performing various
functions, for example,
o authentication and authorization using an existing AAA
(Authentication, Authorization, and Accounting) infrastructure or
via an HLR/AuC (Home Location Register/Authentication Center)
o dynamic allocation of a mobility anchor point
o dynamic allocation of a home address
This document defines an option with a subtype number that denotes a
specific type of identifier. One instance of subtype, the NAI, is
defined in Section 3.1. It is anticipated that other identifiers
will be defined for use in the mobility header in the future.
This option SHOULD be used when Internet Key Exchange (IKE)/IPsec is
not used for protecting binding updates or binding acknowledgements
as specified in [RFC3775]. It is typically used with the
authentication option [RFC4285]. But this option may be used
independently. For example, the identifier can provide accounting
and billing services.
Patel, et al. Standards Track [Page 2]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
2. Terminology
The keywords "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
"SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
document are to be interpreted as described in [RFC2119].
3. Mobile Node Identifier Option
The Mobile Node Identifier option is a new optional data field that
is carried in the Mobile IPv6-defined messages that includes the
Mobility header. Various forms of identifiers can be used to
identify a Mobile Node (MN). Two examples are a Network Access
Identifier (NAI) [RFC4282] and an opaque identifier applicable to a
particular application. The Subtype field in the option defines the
specific type of identifier.
This option can be used in mobility messages containing a mobility
header. The subtype field in the option is used to interpret the
specific type of identifier.
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Option Type | Option Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Subtype | Identifier ...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
Option Type:
MN-ID-OPTION-TYPE has been assigned value 8 by the IANA. It is
an 8-bit identifier of the type mobility option.
Option Length:
8-bit unsigned integer, representing the length in octets of
the Subtype and Identifier fields.
Subtype:
Subtype field defines the specific type of identifier included
in the Identifier field.
Identifier:
A variable length identifier of type, as specified by the
Subtype field of this option.
Patel, et al. Standards Track [Page 3]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
This option does not have any alignment requirements.
3.1. MN-NAI Mobility Option
The MN-NAI mobility option uses the general format of the Mobile Node
Identifier option as defined in Section 3. This option uses the
subtype value of 1. The MN-NAI mobility option is used to identify
the mobile node.
The MN-NAI mobility option uses an identifier of the form user@realm
[RFC4282]. This option MUST be implemented by the entities
implementing this specification.
3.2. Processing Considerations
The location of the MN Identifier option is as follows: When present,
this option MUST appear before any authentication-related option in a
message containing a Mobility header.
4. Security Considerations
4.1. General Considerations
Mobile IPv6 already contains one mechanism for identifying mobile
nodes, the Home Address option [RFC3775]. As a result, the
vulnerabilities of the new option defined in this document are
similar to those that already exist for Mobile IPv6. In particular,
the use of a permanent, stable identifier may compromise the privacy
of the user, making it possible to track a particular device or user
as it moves through different locations.
4.2. MN-NAI Considerations
Since the Mobile Node Identifier option described in Section 3
reveals the home affiliation of a user, it may assist an attacker in
determining the identity of the user, help the attacker in targeting
specific victims, or assist in further probing of the username space.
These vulnerabilities can be addressed through various mechanisms,
such as those discussed below:
o Encrypting traffic at the link layer, such that other users on the
same link do not see the identifiers. This mechanism does not
help against attackers on the rest of the path between the mobile
node and its home agent.
o Encrypting the whole packet, such as when using IPsec to protect
the communications with the home agent [RFC3776].
Patel, et al. Standards Track [Page 4]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
o Using an authentication mechanism that enables the use of privacy
NAIs [RFC4282] or temporary, changing "pseudonyms" as identifiers.
In any case, it should be noted that as the identifier option is only
needed on the first registration at the home agent and subsequent
registrations can use the home address, the window of privacy
vulnerability in this document is reduced as compared to [RFC3775].
In addition, this document is a part of a solution to allow dynamic
home addresses to be used. This is an improvement to privacy as
well, and it affects both communications with the home agent and the
correspondent nodes, both of which have to be told the home address.
5. IANA Considerations
The values for new mobility options must be assigned from the Mobile
IPv6 [RFC3775] numbering space.
The IANA has assigned the value 8 for the MN-ID-OPTION-TYPE.
In addition, IANA has created a new namespace for the subtype field
of the Mobile Node Identifier option. The currently allocated values
are as follows:
NAI (defined in [RFC4282]).
New values for this namespace can be allocated using Standards Action
[RFC2434].
6. Acknowledgements
The authors would like to thank Basavaraj Patil for his review and
suggestions on this document. Thanks to Jari Arkko for review and
suggestions regarding security considerations and various other
aspects of the document.
7. Normative References
[RFC2119] Bradner, S., "Key words for use in RFCs to Indicate
Requirement Levels", BCP 14, RFC 2119, March 1997.
[RFC2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an
IANA Considerations Section in RFCs", BCP 26, RFC 2434,
October 1998.
[RFC3775] Johnson, D., Perkins, C., and J. Arkko, "Mobility
Support in IPv6", RFC 3775, June 2004.
Patel, et al. Standards Track [Page 5]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
[RFC3776] Arkko, J., Devarapalli, V., and F. Dupont, "Using IPsec
to Protect Mobile IPv6 Signaling Between Mobile Nodes
and Home Agents", RFC 3776, June 2004.
[RFC4282] Aboba, B., Beadles, M., Arkko, J., and P. Eronen, "The
Network Access Identifier", RFC 4282, November 2005.
8. Informative Reference
[RFC4285] Patel, A., Leung, K., Khalil, M., Akhtar, H., and K.
Chowdhury, "Authentication Protocol for Mobile IPv6",
RFC 4285, November 2005.
Authors' Addresses
Alpesh Patel
Cisco Systems
170 W. Tasman Drive
San Jose, CA 95134
US
Phone: +1 408-853-9580
EMail: alpesh@cisco.com
Kent Leung
Cisco Systems
170 W. Tasman Drive
San Jose, CA 95134
US
Phone: +1 408-526-5030
EMail: kleung@cisco.com
Mohamed Khalil
Nortel Networks
2221 Lakeside Blvd.
Richardson, TX 75082
US
Phone: +1 972-685-0574
EMail: mkhalil@nortel.com
Patel, et al. Standards Track [Page 6]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
Haseeb Akhtar
Nortel Networks
2221 Lakeside Blvd.
Richardson, TX 75082
US
Phone: +1 972-684-4732
EMail: haseebak@nortel.com
Kuntal Chowdhury
Starent Networks
30 International Place
Tewksbury, MA 01876
US
Phone: +1 214 550 1416
EMail: kchowdhury@starentnetworks.com
Patel, et al. Standards Track [Page 7]
RFC 4283 Mobile Node Identifier Option for MIPv6 November 2005
Full Copyright Statement
Copyright (C) The Internet Society (2005).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at ietf-
ipr@ietf.org.
Acknowledgement
Funding for the RFC Editor function is currently provided by the
Internet Society.
Patel, et al. Standards Track [Page 8]
Html markup produced by rfcmarkup 1.129b, available from
https://tools.ietf.org/tools/rfcmarkup/
