RFC 1853 IP in IP Tunneling

[Docs] [txt|pdf] [Tracker]

INFORMATIONAL

Network Working Group                                         W. Simpson
Request for Comments: 1853                                    Daydreamer
Category: Informational                                     October 1995


                           IP in IP Tunneling


Status of this Memo

   This memo provides information for the Internet community.  It does
   not specify an Internet standard.  Distribution of this memo is
   unlimited.


IESG Note:

   Note that this memo is an individual effort of the author.  This
   document reflects a current informal practice in the internet.  There
   is an effort underway within the IETF Mobile-IP Working Group to
   provide an appropriate proposed standard to address this issue.


Abstract

   This document discusses implementation techniques for using IP
   Protocol/Payload number 4 Encapsulation for tunneling with IP
   Security and other protocols.


Table of Contents

     1.     Introduction ..........................................    2

     2.     Encapsulation .........................................    3

     3.     Tunnel Management .....................................    5
        3.1       Tunnel MTU Discovery ............................    5
        3.2       Congestion ......................................    6
        3.3       Routing Failures ................................    6
        3.4       Other ICMP Messages .............................    6

     SECURITY CONSIDERATIONS ......................................    7
     REFERENCES ...................................................    7
     ACKNOWLEDGEMENTS .............................................    8
     AUTHOR'S ADDRESS .............................................    8





Simpson                      Informational                      [Page 1]


RFC 1853                     IP Tunnelling                  October 1995


1.  Introduction

   The IP in IP encapsulation Protocol/Payload number 4 [RFC-1700] has
   long been used to bridge portions of the Internet which have disjoint
   capabilities or policies.  This document describes implementation
   techniques used for many years by the Amateur Packet Radio network
   for joining a large mobile network, and also by early implementations
   of IP Security protocols.

   Use of IP in IP encapsulation differs from later tunneling techniques
   (for example, protocol numbers 98 [RFC-1241], 94 [IDM91a], 53
   [swIPe], and 47 [RFC-1701]) in that it does not insert its own
   special glue header between IP headers.  Instead, the original
   unadorned IP Header is retained, and simply wrapped in another
   standard IP header.

   This information applies principally to encapsulation of IP version
   4.  Other IP versions will be described in separate documents.

































Simpson                      Informational                      [Page 2]


RFC 1853                     IP Tunnelling                  October 1995


2.  Encapsulation

   The encapsulation technique is fairly simple.  An outer IP header is
   added before the original IP header.  Between them are any other
   headers for the path, such as security headers specific to the tunnel
   configuration.

   The outer IP header Source and Destination identify the "endpoints"
   of the tunnel.  The inner IP header Source and Destination identify
   the original sender and recipient of the datagram.

   Each header chains to the next using IP Protocol values [RFC-1700].

                                          +---------------------------+
                                          |      Outer IP Header      |
                                          +---------------------------+
                                          |      Tunnel Headers       |
      +---------------------------+       +---------------------------+
      |         IP Header         |       |      Inner IP Header      |
      +---------------------------+ ====> +---------------------------+
      |                           |       |                           |
      |         IP Payload        |       |         IP Payload        |
      |                           |       |                           |
      +---------------------------+       +---------------------------+

   The format of IP headers is described in [RFC-791].

   Type Of Service  copied from the inner IP header.  Optionally,
                    another TOS may be used between cooperating peers.

                    This is in keeping with the transparency principle
                    that if the user was expecting a given level of
                    service, then the tunnel should provide the same
                    service.  However, some tunnels may be constructed
                    specifically to provide a different level of service
                    as a matter of policy.

   Identification   A new number is generated for each outer IP header.

                    The encapsulated datagram may have already been
                    fragmented, and another level of fragmentation may
                    occur due to the tunnel encapsulation.  These tunnel
                    fragments will be reassembled by the decapsulator,
                    rather than the final destination.

   Reserved
                    ignored (set to zero).




Simpson                      Informational                      [Page 3]


RFC 1853                     IP Tunnelling                  October 1995


                    This unofficial flag has seen experimental use, and
                    while it remains in the inner IP header, does not
                    affect the tunnel.

   Don't Fragment   copied from the inner IP header.  This allows the
                    originator to control the level of performance
                    tradeoffs.  See "Tunnel MTU Discovery".

   More Fragments   set as required when fragmenting.

                    The flag is not copied for the same reason that a
                    separate Identification is used.

   Time To Live     the default value specified in the most recent
                    "Assigned Numbers" [RFC-1700].  This ensures that
                    long unanticipated tunnels do not interrupt the flow
                    of datagrams between endpoints.

                    The inner TTL is decremented once before
                    encapsulation, and is not affected by decapsulation.

   Protocol         the next header; 4 for the inner IP header, when no
                    intervening tunnel headers are in use.

   Source           an IP address associated with the interface used to
                    send the datagram.

   Destination      an IP address of the tunnel decapsulator.

   Options          not copied from the inner IP header.  However, new
                    options particular to the path MAY be added.

                    Timestamp, Loose Source Route, Strict Source Route,
                    and Record Route are deliberately hidden within the
                    tunnel.  Often, tunnels are constructed to overcome
                    the inadequacies of these options.

                    Any supported flavors of security options of the
                    inner IP header MAY affect the choice of security
                    options for the tunnel.  It is not expected that
                    there be a one-to-one mapping of such options to the
                    options or security headers selected for the tunnel.









Simpson                      Informational                      [Page 4]


RFC 1853                     IP Tunnelling                  October 1995


3.  Tunnel Management

   It is possible that one of the routers along the tunnel interior
   might encounter an error while processing the datagram, causing it to
   return an ICMP [RFC-792] error message to the encapsulator at the IP
   Source of the tunnel.  Unfortunately, ICMP only requires IP routers
   to return 8 bytes (64 bits) of the datagram beyond the IP header.
   This is not enough to include the entire encapsulated header.  Thus,
   it is not generally possible for an encapsulating router to
   immediately reflect an ICMP message from the interior of a tunnel
   back to the originating host.

   However, by carefully maintaining "soft state" about its tunnels, the
   encapsulator can return accurate ICMP messages in most cases.  The
   router SHOULD maintain at least the following soft state information
   about each tunnel:

    - Reachability of the end of the tunnel.
    - Congestion of the tunnel.
    - MTU of the tunnel.

   The router uses the ICMP messages it receives from the interior of a
   tunnel to update the soft state information for that tunnel.  When
   subsequent datagrams arrive that would transit the tunnel, the router
   checks the soft state for the tunnel.  If the datagram would violate
   the state of the tunnel (such as the MTU is greater than the tunnel
   MTU when Don't Fragment is set), the router sends an appropriate ICMP
   error message back to the originator, but also forwards the datagram
   into the tunnel.  Forwarding the datagram despite returning the error
   message ensures that changes in tunnel state will be learned.

   Using this technique, the ICMP error messages from encapsulating
   routers will not always match one-to-one with errors encountered
   within the tunnel, but they will accurately reflect the state of the
   network.


3.1.  Tunnel MTU Discovery

   When the Don't Fragment bit is set by the originator and copied into
   the outer IP header, the proper MTU of the tunnel will be learned
   from ICMP (Type 3 Code 4) "Datagram Too Big" errors reported to the
   encapsulator.  To support originating hosts which use this
   capability, all implementations MUST support Path MTU Discovery
   [RFC-1191, RFC-1435] within their tunnels.






Simpson                      Informational                      [Page 5]


RFC 1853                     IP Tunnelling                  October 1995


   As a benefit of Tunnel MTU Discovery, any fragmentation which occurs
   because of the size of the encapsulation header is done only once
   after encapsulation.  This prevents more than one fragmentation of a
   single datagram, which improves processing efficiency of the path
   routers and tunnel decapsulator.


3.2.  Congestion

   Tunnel soft state will collect indications of congestion, such as an
   ICMP (Type 4) Source Quench in datagrams from the decapsulator
   (tunnel peer).  When forwarding another datagram into the tunnel,
   it is appropriate to send Source Quench messages to the originator.


3.3.  Routing Failures

   Because the TTL is reset each time that a datagram is encapsulated,
   routing loops within a tunnel are particularly dangerous when they
   arrive again at the encapsulator.  If the IP Source matches any of
   its interfaces, an implementation MUST NOT further encapsulate.
   Instead, the datagram is forwarded normally.

   ICMP (Type 11) Time Exceeded messages report routing loops within the
   tunnel itself.  ICMP (Type 3) Destination Unreachable messages report
   delivery failures to the decapsulator.  This soft state MUST be
   reported to the originator as (Type 3 Code 0) Network Unreachable.


3.4.  Other ICMP Messages

   Most ICMP error messages are not relevant to the use of the tunnel.
   In particular, parameter problems are likely to be a result of
   misconfiguration of the encapsulator, and MUST NOT be reported to the
   originator.
















Simpson                      Informational                      [Page 6]


RFC 1853                     IP Tunnelling                  October 1995


Security Considerations

   Security issues are briefly discussed in this memo.  The use of
   tunneling may obviate some older IP security options (labelling), but
   will better support newer IP Security headers.


References

   [IDM91a] Ioannidis, J., Duchamp, D., Maguire, G., "IP-based
            protocols for mobile internetworking", Proceedings of
            SIGCOMM '91, ACM, September 1991.

   [RFC-791]
            Postel, J., "Internet Protocol", STD 5, RFC 791,
            USC/Information Sciences Institute, September 1981.

   [RFC-792]
            Postel, J., "Internet Control Message Protocol", STD 5,
            RFC 792, USC/Information Sciences Institute, September
            1981.

   [RFC-1191]
            Mogul, J., and S. Deering, "Path MTU Discovery", RFC 1191,
            DECWRL, Stanford University, November 1990.

   [RFC-1241]
            Mills, D., and R. Woodburn, "A Scheme for an Internet
            Encapsulation Protocol: Version 1", UDEL, July 1991.

   [RFC-1435]
            Knowles, S., "IESG Advice from Experience with Path MTU
            Discovery", RFC 1435, FTP Software, March 1993.

   [RFC-1700]
            Reynolds, J., and J. Postel, "Assigned Numbers", STD 2, RFC
            1700, USC/Information Sciences Institute, October 1994.

   [RFC-1701]
            Hanks, S., Li, T., Farinacci, D., and P. Traina, "Generic
            Routing Encapsulation (GRE)", RFC 1701, October 1994.

   [swIPe]  Ioannidis, J., and Blaze, M., "The Architecture and
            Implementation of Network-Layer Security Under Unix", Fourth
            Usenix Security Symposium Proceedings, October 1993.






Simpson                      Informational                      [Page 7]


RFC 1853                     IP Tunnelling                  October 1995


Acknowledgements

   These implementation details of IP Tunneling are derived in large
   part from independent work in 1990 by Phil Karn and the TCP-Group
   hams using KA9Q NOS.

   Special thanks to John Ioannidis (then of Columbia University) for
   inspiration and experimentation which began this most recent round of
   IP Mobility and IP Security development.  Some of this text was
   derived from [IDM91a] and [swIPe].

   The chaining of headers was also described in "Simple Internet
   Protocol", by Steve Deering (Xerox PARC).

   The overall organization and some of this text was derived from
   [RFC-1241], by David Mills (U Delaware) and Robert Woodburn (SAIC).

   Some of the text on tunnel soft state was derived from "IP Address
   Encapsulation (IPAE)", by Robert E. Gilligan, Erik Nordmark, and Bob
   Hinden (all of Sun Microsystems).


Author's Address

   Questions about this memo can also be directed to:

      William Allen Simpson
      Daydreamer
      Computer Systems Consulting Services
      1384 Fontaine
      Madison Heights, Michigan  48071

      Bill.Simpson@um.cc.umich.edu
          bsimpson@MorningStar.com

















Simpson                      Informational                      [Page 8]


Html markup produced by rfcmarkup 1.129b, available from https://tools.ietf.org/tools/rfcmarkup/