RFC 2711 IPv6 Router Alert Option

[Docs] [txt|pdf] [draft-ietf-ipng...] [Tracker] [Diff1] [Diff2]

Updated by: 6398 PROPOSED STANDARD

Network Working Group                                      C. Partridge
Request for Comments: 2711                                          BBN
Category: Standards Track                                    A. Jackson
                                                                    BBN
                                                           October 1999


                        IPv6 Router Alert Option

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (1999).  All Rights Reserved.

Abstract

   This memo describes a new IPv6 Hop-by-Hop Option type that alerts
   transit routers to more closely examine the contents of an IP
   datagram.  This option is useful for situations where a datagram
   addressed to a particular destination contains information that may
   require special processing by routers along the path.

1.0  Introduction

   New protocols, such as RSVP, use control datagrams which, while
   addressed to a particular destination, contain information that needs
   to be examined, and in some case updated, by routers along the path
   between the source and destination.  It is desirable to forward
   regular datagrams as rapidly as possible, while ensuring that the
   router processes these special control datagrams appropriately.
   Currently, however, the only way for a router to determine if it
   needs to examine a datagram is to at least partially parse upper
   layer data in all datagrams.  This parsing is expensive and slow.
   This situation is undesirable.

   This document defines a new option within the IPv6 Hop-by-Hop Header.
   The presence of this option in an IPv6 datagram informs the router
   that the contents of this datagram is of interest to the router and
   to handle any control data accordingly.  The absence of this option
   in an IPv6 datagram informs the router that the datagram does not
   contain information needed by the router and hence can be safely



Partridge & Jackson         Standards Track                     [Page 1]


RFC 2711                IPv6 Router Alert Option            October 1999


   routed without further datagram parsing.  Hosts originating IPv6
   datagrams are required to include this option in certain
   circumstances.

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in [RFC-2119].

2.0  Approach

   The goal is to provide an efficient mechanism whereby routers can
   know when to intercept datagrams not addressed to them without having
   to extensively examine every datagram.  The described solution is to
   define a new IPv6 Hop-by-Hop Header option having the semantic
   "routers should examine this datagram more closely" and require
   protocols such as RSVP to use this option.  This approach incurs
   little or no performance penalty on the forwarding of normal
   datagrams.  Not including this option tells the router that there is
   no need to closely examine the contents of the datagram.

2.1  Syntax

   The router alert option has the following format:

   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
   |0 0 0|0 0 1 0 1|0 0 0 0 0 0 1 0|        Value (2 octets)       |
   +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
                      length = 2

      The first three bits of the first byte are zero and the value 5 in
      the remaining five bits is the Hop-by-Hop Option Type number.
      [RFC-2460] specifies the meaning of the first three bits.  By
      zeroing all three, this specification requires that nodes not
      recognizing this option type should skip over this option and
      continue processing the header and that the option must not change
      en route.

      There MUST only be one option of this type, regardless of value,
      per Hop-by-Hop header.












Partridge & Jackson         Standards Track                     [Page 2]


RFC 2711                IPv6 Router Alert Option            October 1999


      Value:  A 2 octet code in network byte order with the following
      values:

         0        Datagram contains a Multicast Listener Discovery
                  message [RFC-2710].
         1        Datagram contains RSVP message.
         2        Datagram contains an Active Networks message.
         3-65535  Reserved to IANA for future use.

      Alignment requirement: 2n+0

      Values are registered and maintained by the IANA.  See section 5.0
      for more details.

2.2  Semantics

   The option indicates that the contents of the datagram may be
   interesting to the router.  The router's interest and the actions
   taken by employing Router Alert MUST be specified in the RFC of the
   protocol that mandates or allows the use of Router Alert.

   The final destination of the IPv6 datagram MUST ignore this option
   upon receipt to prevent multiple evaluations of the datagram.
   Unrecognized value fields MUST be silently ignored and the processing
   of the header continued.

   Routers that recognize the option will examine datagrams carrying it
   more closely to determine whether or not further processing is
   necessary.  The router only needs to parse the packet in sufficient
   detail to decide whether the packet contains something of interest.
   The value field can be used by an implementation to speed processing
   of the datagram within the transit router.

   Observe that further processing can involve protocol layers above
   IPv6.  E.g., for RSVP messages, the datagram will have to undergo UDP
   and RSVP protocol processing.  Once the datagram leaves the IPv6
   layer, there is considerable ambiguity about whether the router is
   acting as an IPv6 host or an IPv6 router.  Precisely how the router
   handles the contents is value-field specific.  However, if the
   processing required for the datagram involves examining the payload
   of the IPv6 datagram, then the interim router is performing a host
   function and SHOULD interpret the data as a host.









Partridge & Jackson         Standards Track                     [Page 3]


RFC 2711                IPv6 Router Alert Option            October 1999


3.0  Impact on Other Protocols

   For this option to be effective, its use MUST be mandated in
   protocols that expect routers to perform significant processing on
   datagrams not directly addressed to them.  Routers are not required
   to examine the datagrams not addressed to them unless the datagrams
   include the router alert option.

   All IPv6 datagrams containing an RSVP message MUST contain this
   option within the IPv6 Hop-by-Hop Options Header of such datagrams.

4.0  Security Considerations

   Gratuitous use of this option can cause performance problems in
   routers.  A more severe attack is possible in which the router is
   flooded by bogus datagrams containing router alert options.

   The use of the option, if supported in a router, MAY therefore be
   limited by rate or other means by the transit router.

5.0 IANA Considerations

   The value field described in Section 2.1 is registered and maintained
   by IANA. New values are to be assigned via IETF Consensus as defined
   in RFC 2434 [RFC-2434].

6.0  Notice on Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   intellectual property or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; neither does it represent that it
   has made any effort to identify any such rights.  Information on the
   IETF's procedures with respect to rights in standards-track and
   standards-related documentation can be found in BCP-11.  Copies of
   claims of rights made available for publication and any assurances of
   licenses to be made available, or the result of an attempt made to
   obtain a general license or permission for the use of such
   proprietary rights by implementors or users of this specification can
   be obtained from the IETF Secretariat.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights which may cover technology that may be required to practice
   this standard.  Please address the information to the IETF Executive
   Director.




Partridge & Jackson         Standards Track                     [Page 4]


RFC 2711                IPv6 Router Alert Option            October 1999


7.0  References

   [RFC-2119] Bradner, S., "Key words for use in RFC's to Indicate
              Requirement Levels", BCP 14, RFC 2119, March 1977.

   [RFC-2205] Braden, B. (ed.), Zhang, L., Berson, S., Herzog, S. and S.
              Jamin, "Resource ReSerVation Protocol (RSVP)", RFC 2205,
              September 1997.

   [RFC-2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an
              IANA Considerations Section in RFCs", BCP 26, RFC 2434,
              October 1998.

   [RFC-2460] Deering, S. and R. Hinden, "Internet Protocol, Version 6
              (IPv6) Specification", RFC 2460, December 1998.

   [RFC-2710] Deering, S., Fenner, W. and B. Haberman, "Multicast
              Listener Discovery (MLD) for IPv6", RFC 2710, October
              1999.

6.0  Authors' Addresses

   Craig Partridge
   BBN Technologies
   10 Moulton Street
   Cambridge, MA 02138
   USA

   Phone: +1 (617) 873-3000
   EMail: craig@bbn.com


   Alden Jackson
   BBN Technologies
   10 Moulton Street
   Cambridge, MA 02138
   USA

   Phone: +1 (617) 873-3000
   EMail: awjacks@bbn.com











Partridge & Jackson         Standards Track                     [Page 5]


RFC 2711                IPv6 Router Alert Option            October 1999


7.0  Full Copyright Statement

   Copyright (C) The Internet Society (1999).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.



















Partridge & Jackson         Standards Track                     [Page 6]


Html markup produced by rfcmarkup 1.129b, available from https://tools.ietf.org/tools/rfcmarkup/